How to curb.< Volver
One of the key for a spectacular swimming pool is kept in perfect union boards. This results in easier maintenance, preventing the accumulation of dirt and algae that will give you a look neglected.

Curb


One of the key for a spectacular swimming pool is kept in perfect union boards. This results in easier maintenance, preventing the accumulation of dirt and algae that will give you a look neglected.

 

 

 

The process for regenerating a curb is as follows:
1.Disconnecting the pool lights.Keep in mind that usually melt or leave damaged lamp lights if the programmer without being submerged.
2.Clearing the pool closes for security reasons.
3.Removal of all levels and moving parts, such as returns, cleaner covers, skimmer gates or lights.Filling the tubes open with rags to prevent the cement into the holes.
4.Cleaning with water pressure.This allows a great deal of clean dirt and organic matter existing.
5.Cleaning the pool with a solution of hydrochloric acid.We recommend placing first four parts of water and mix it with one part of hydrochloric.Interestingly the spray solution to spray acid (if it is a normal kind phytosanitary joints deteriorate).Should always be prepared glasses, a full body protective suit, boots and slip.Must also take special gloves and a mask of inorganic vapors.
6.Neutralization of the acid from the walls.The white cement costing join acidic surfaces.It will be interesting to neutralize this acid cleaning first with water, then 5% sodium bicarbonate using the same sulfatadora.(Before we removed the acid through a triple cleaning)
7.Brushing. Now, little is left curb, is brittle and is easy to remove with a strong past stiff bristle brush. It is important that it is a good gap between gresites to facilitate the entry of cement.
8. Placement of concrete. We will supply white cement curbs special pools. You may find it in different colors. Always follow the instructions that the manufacturer prescribes. It will be important to moisten the surface with water sprayer helping us a small one or two liters of water. We mortar mix and water in a basket with a palette and stirring until the mixture acquires the consistency of honey. If it is very clear, the result is a cement fragile, if it's thick, it will cost us to apply it. Reject all or hardening cement once it is on the ground. Of particular interest are the special cements (type Microban ®) to inhibit bacterial growth or mildew.

 

 

9. Apply the paste preferably with a flat rubber. All passes are diagonally never parallel to the boards. We will make several passes, allowing the entire cavity remains filled with cement. All we did was mix completed within ten minutes. Let dry cement, and then spend a dampened sponge to remove the cement deposited on the tile.
10. The water will be filled as quickly as possible, allowing the setting of cement takes place underwater. When filled, never leave the stream directly affect the fresh cement. Start filling hose or through the sump.
11. Now we follow the protocol implementation of the pool.

We hope you have been helpful.
I swim!

Imagen de seguimiento